Leitner Wireless Headset Mitel Electronic Hookswitch Setup

  1. Unplug the power cord from your Leitner base
  2. Set the switches on the bottom of the base to DHSG and 1
  3. Grab the Y-cable of the EHS. Connect the single end to the AUX port on your telephone
  4. Connect larger cable of the Y-end to the AUX port on Leitner base. Smaller end goes into green TEL port on the base
  5. Plug your power cord back in
  6. *For Mitel phones, you may need to enable DHSG headset mode in your phone settings. This typically is found under "Headset" in your phone's audio settings